ZIS360NR – GE Monogram 36" Built-In Side-by-Side Refrigerator
with Automatic Icemaker and Water Filter
The Installation Space
35"
Case Width
* Shipping height.
The refrigerator
36" Models 12"
42" Models 18"
48" Models 20"
25-3/4"
can be adjusted to
fit into a cutout that
is 83-1/2" min. to
84-1/2" max. height
The top case trim
*Finished Width
*84" From
Floor to
Top Frame
*83-1/2"
at
Rear
at the front is 1/2"
higher and will
overlap upper
6"
Electrical
Area
84-1/2" max
83-1/2" min
Finished
5"
cabinetry or soffit.
Use leveling legs
and wheels for a
maximum 1" height
adjustment.
75" From Floor
to Bottom
of Electrical
Area
Opening
24"
5"
36"
27-3/4"
including
handle
Frame to Frame
5"
Water Supply
3-1/2"
Door Swing Clearances
3-1/2"
The installation must allow for clearances to adjacent walls or
cabinets. These refrigerators are equipped with a 2-position
door stop. The factory-set 130° door swing can be adjusted to
90° if clearance to adjacent cabinets or walls is restricted.
Space is the first consideration when planning the installation.
The cutout depth must be 24"
The refrigerator will project forward, slightly beyond adjacent
cabinetry, depending on your installation.
90° Door Swing
130° Door Swing
The cutout depth beneath a soffit
13"
19"
23-7/8"
Behind
Frame
When installed beneath a soffit, the soffit cannot exceed the
24" installation depth shown. The top case trim overlaps the
bottom of the soffit.
Electrical
20-5/8"
A 115V, 60Hz., 15 or 20 amp power supply is required. An
individual properly grounded branch circuit or circuit breaker
is recommended. Install a properly grounded 3-prong electrical
receptacle recessed into the back wall. Electrical must be
located on rear wall as shown.
4" Min.
to Wall
Allow minimum clearances for freezer door and fresh food
door for a full 130° door swing and to allow for pan removal.
Note: GFI (ground fault interrupter) is not recommended.
• 4" minimum clearance is required when door swing is
adjusted to 90°. If the 90° door stop position is used, pan
access is maintained, but pan removal is restricted.
• See door swing illustrations to determine interaction with
adjacent cabinets or countertops.
Water Line
All models are equipped with an automatic icemaker. The
water line can enter the opening through the floor or back
wall. Route 1/4" O.D. copper tubing or GE QuickConnect
kit between the cold water line and the water connection
location. The copper tubing should be long enough to extend
to the front of the refrigerator. The installation of an easily
accessible shut-off valve in the water line is required.
Installation Information: Before installing, consult
installation instructions packed with product, or online at
Monogram.com, for current dimensional data.
For answers to your Monogram,® gE Profile™ or
As an EnErgy StAr®
partner, gE has determined
that this product meets the
EnErgy StAr guidelines
for energy efficiency.
gE® appliance questions, visit our website at
Listed by
Underwriters
Laboratories
gEAppliances.com or call
gE Answer Center® service, 800.626.2000.
Specification Revised 3/08
110110
ZIS360NR – GE Monogram 36" Built-In Side-by-Side Refrigerator
with Automatic Icemaker and Water Filter
3/4" Overlay Panel Dimensions
Important Note: Maximum total
panel weight:
• Fresh food door panel – 75 lbs.
• Freezer door panel – 53 lbs.
• grille panel – 18 lbs.
For a more custom appearance, overlay
panels may be installed on trimmed
models. the overlay panel must be
secured to a 1/4"-thick backer panel
which slides into the trim. A spacer
panel 0.10" thick must be placed
A
Door
Grille Panel
B
3/4"
Overlay
Panel
between the overlay and backer panels.
.250" + .10" + .750" =
1.100" total Panel thickness
C
1/4"
Backer
Panel
.10"
Spacer
Freezer
Fresh Food
Panel
Overlay Panel
Spacer Panel
Backer Panel
Panel
Center each panel over the other.
Assemble the panels with glue
and screws. Screws must be
D
E
countersunk into the backer panel.
36" Side-by-Side (in inches)
A
1/4" Backer Panel 33-7/8
.10" Spacer Panel 33
B
C
D
E
NOTE: Left-to-right offset
is not always equal to
top-to-bottom offset.
9
68-3/8 14-9/16 18-9/16
13-1/4 17-1/4
8-3/8 67
3/4" Spacer Panel 34-1/8 9-1/4 68-5/8 14-13/16 18-13/16
1/4" Framed Panel Dimensions
If you choose to install framed panels,
they must be cut to the dimensions
shown. the panels will slide into the
frame on the door and grille.
33-7/8"
5/16"
Trim
Reveal
Grille Panel
9"
Door
If the custom panel is less than 1/4" thick,
and it fits loosely in the door frame, it can
be backed up with a piece of filler material
or foam tape to improve the fit.
1/4"
Panel
Important Note: Maximum weight for
fresh food panel is 50 pounds and 30
pounds for freezer panel.
68-3/8"
Freezer
Panel
Fresh Food
Panel
14-19/16"
18-9/16"
For answers to your Monogram,® gE Profile™ or
gE® appliance questions, visit our website at
gEAppliances.com or call
As an EnErgy StAr®
partner, gE has determined
that this product meets the
EnErgy StAr guidelines
for energy efficiency.
Listed by
Underwriters
Laboratories
gE Answer Center® service, 800.626.2000.
Specification Revised 3/08
110110
ZIS360NR – GE Monogram 36" Built-In Side-by-Side
Refrigerator with Automatic Icemaker
and Water Filter
Advance Planning for Built-In Custom Side-by-Side Refrigerators
Use this page to determine door swing
interaction with adjacent cabinets
or countertops.
Frameless Cabinets: the case trim overlaps
cabinets at the top and sides. therefore,
frameless cabinets may require filler strips
to prevent interference with cabinet door swing.
the opening must allow for filler strips.
Refrigerator
23-7/8" From
Rear of
Refrigerator
1"
2"
1-3/4"
3"
2-3/4"
Case
Trim
3/4"
1/2"
1/4"
1-1/2"
1-1/4"
2-1/2"
2-1/4"
Top View
130° Door Swing
(Factory setting)
Scale 1:1
1/4"
1/2"
3/4"
1"
IMPORTANT NOTE –
FOR DISPENSER MODELS
Dispenser models are supplied with
two dispenser trims, one to fit framed panels
and one for overlay panels. Dispenser trim fit
to the custom panel depends on correct
panel thickness. Framed panels
must be 1/4" nominal. Overlay panels
should be constructed as shown
to accomplish a total
1.100" thickness.
1/4"
1/2"
3/4"
1"
1-1/4"
Door
3/4" Overlay
Panel
(Nominal Size)
Listed by
Underwriters
Laboratories
As an EnErgy StAr®
partner, gE has determined
that this product meets the
EnErgy StAr guidelines
for energy efficiency.
For answers to your Monogram,® gE Profile™ or
gE® appliance questions, visit our website at
gEAppliances.com or call
gE Answer Center® service, 800.626.2000.
Specification Created 1/04
110110
ZIS360NR – GE Monogram 36" Built-In Side-by-Side
Refrigerator with Automatic Icemaker
and Water Filter
Advance Planning for Built-In
Side-by-Side Refrigerators
Use this page to determine door swing
interaction with adjacent cabinets
or countertops.
Refrigerator
Case Trim
23-7/8"
From Rear of
Refrigerator
Frameless Cabinets: the case trim overlaps
cabinets at the top and sides. therefore,
frameless cabinets may require filler strips
to prevent interference with cabinet door swing.
the opening must allow for filler strips.
1/4"
1/2"
3/4"
1"
1-1/4"
1-1/2"
Top View
90° Door Swing
(Optional setting)
Scale 1:1
IMPORTANT NOTE –
FOR DISPENSER MODELS
Dispenser models are supplied with two dispenser
trims, one to fit framed panels and one for overlay
panels. Dispenser trim fit to the custom panel
depends on correct panel thickness. Framed
panels must be 1/4" nominal. Overlay panels
should be constructed as shown to accomplish
a total 1.100" thickness.
1/4"
Door
1/2"
3/4"
Listed by
Underwriters
Laboratories
1"
As an EnErgy StAr®
partner, gE has determined
that this product meets the
EnErgy StAr guidelines
for energy efficiency.
1-1/4"
3/4" Overlay
Panel
(Nominal Size)
For answers to your Monogram,® gE Profile™ or
gE® appliance questions, visit our website at
gEAppliances.com or call
gE Answer Center® service, 800.626.2000.
Specification Revised 3/08
110110
ZIS360NR – GE Monogram 36" Built-In Side-by-Side Refrigerator
with Automatic Icemaker and Water Filter
Features and Benefits
• 21.6 cu. ft. total capacity
• Integrated Ice™ System – the ice bucket is integrated
into the icemaker, not the freezer door, freeing up
valuable storage space
• Upfront electronic controls with digital readout
• Multi-shelf halogen light tower (Both fresh food
and freezer section)
• Multi-shelf air management tower
• Climate control drawer with Express Chill,
Express thaw and Select temp
• Sealed adjustable humidity produce pan with
easy access lid and full extension slides
• 4 spill proof glass fresh food cabinet shelves
(3 adj./1 fixed)
• Model ZIS360nr – non-dispenser model
Specification Revised 3/08
110110
|