INSTALLATION INSTRUCTIONS FOR PART GMLAN29-100
GMLAN29-100
*Read Important Warning On Page 1
Before Attempting Any Installation*
The GMLAN29-100 is designed to and MUST be used with the
GMOS-100i (SOLD SEPERATELY). Please refer to GMOS-100i
for 20 pin connector instructions
APPLICATIONS
BUICK
GMC
Enclave 2007-10
Lucerne 2006-10
Acadia 2007-10
Savanna 2008-10
Sierra (New body) 2007-10
Yukon 2007-10
CADILLAC
Escalade 2007-10
DTS 2006-10
SRX 2007-09
HUMMER
H2 2008-09
CHEVROLET
PONTIAC
Avalanche 2007-10
Equinox 2007-09
Express 2008-10
Torrent 2007-09
Vibe 2009
Impala 2006-2010
Monte Carlo 2006-2007
Silverado (new body) 2007-10
Suburban 2007-09
Tahoe 2007-09
SATURN
Outlook 2007-09
Vue 2008-09
SUZUKI
XL-7 2007-09
Traverse 2009
1-800-221-0932
axxessinterface.com
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
TABLE OF CONTENTS
Installing The Interface .............................................................. 1
Installing The GMLAN29-100 ................................................. 1
Programming SWC ..................................................................... 2
Testing The GMLAN29-100 ...................................................... 2
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP certified
technicians
*Important: Before beginning any of the following,
disconnect the negative battery terminal to prevent an
accidental short circuit.
INSTALLING THE INTERFACE
From the 22 way harness:
•
•
Connect the Black wire with the ring terminal to the back of the aftermarket radios chasis
Connectthe3.5mmjacktoyouraftermarketradiossteeringwheelcontrolinput(if
equipped)
From the 30 way harness:
•
•
Connect the Black wire to the ground wire of the aftermarket radio
ConnecttheRCA’sonthe8pinharnesstotheAUXinontheaftermarketradio(if
equipped)
•
Connect the Yellow wire to the constant wire of the aftermarket radio.
TheGMLAN29-100comessetupforamplifiedsystems. Ifthevehicleisnotamplified
disconnect the 4 pin harness located between the 30 way and 22 way connector. Connect
the supplied 4 pin speaker harness and connect the following:
•
•
•
•
Connect the Violet wire to the right rear positive wire of the aftermarket radio
Connect the Violet/Black wire to the right rear negative wire of the aftermarket radio
Connect the Green wire to the left rear positive wire of the aftermarket radio
Connect the Green/Black wire to the left rear negative wire of the aftermarket radio
INSTALLING THE GMLAN29-100
Withalltheconnectionscompleted, plugthe20, 22, and8pinharnessesintotheGMOS-100i
(sold separately).
•
•
Reconnect the negative battery terminal.
Plug the 30 pin GM harness into the vehicle side harness, and plug the aftermarket radio
harnessintotheaftermarketradio.
•
Cycle the key by turning the ignition on then back off, then back on again to test the radio.
1
PROGRAMMINGSWC
•
•
•
•
Turn on the ignition
The LED will begin to blink rapidly
Turn on the aftermarket radio
Press volume up until radio responses
TESTING THE GMLAN29-100
•
•
Turntheignitionon, andthenturntheaftermarketradioon.
PushtheOnstarbutton, theradioshouldturnoff(radiowillmuteifmutewireis
connected)andyoushouldhearOnstar. PushtheOnstarcancelbuttonandtheradio
should come back on.
2
NOTES
NOTES
INSTALLATION INSTRUCTIONS FOR PART GMLAN29-100
1-800-221-0932
axxessinterface.com
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
|