INSTALLATION INSTRUCTIONS FOR PART GMLAN11-100
GMLAN11-100
*Read Important Warning On Page 1
Before Attempting Any Installation*
The GMLAN11-100 is designed to and MUST be used with the
GMOS-100i (SOLD SEPERATELY). Please refer to GMOS-100i
for 20 pin connector instructions.
APPLICATIONS
CHEVROLET
Cobalt 2007-10
HHR 2006-10
Malibu 2008-10
PONTIAC
G5 2007-08
G6 2009
Solstice 2006-09
SATURN
Aura 2006-09
Sky 2006-09
1-800-221-0932
axxessinterface.com
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
TABLE OF CONTENTS
Installing The Interface .............................................................. 1
Installing The GMLAN11-100 ................................................. 1
Programming SWC ..................................................................... 2
Testing The GMLAN11-100 ...................................................... 2
KNOWLEDGE IS POWER
Enhance your installation and fabrication skills by
enrolling in the most recognized and respected
mobile electronics school in our industry.
800-354-6782 for more information and take steps
toward a better tomorrow.
Metra recommends MECP certified
technicians
*Important: Before beginning any of the following,
disconnect the negative battery terminal to prevent an
accidental short circuit.
INSTALLING THE INTERFACE
From the 22 way harness:
•
•
Connect the Black wire with the ring terminal to the back of the aftermarket radios chasis
Connectthe3.5mmjacktoyouraftermarketradiossteeringwheelcontrolinput(if
equipped)
Fromthe30wayharness:
•
•
Connect the Black wire to the ground wire of the aftermarket radio
ConnecttheRCA’son8pinharnesstotheAUXinontheaftermarketradio(ifequipped)
The XIA-LCD is need to view Satellite stations (sold separately)
Connect the Yellow wire to the constant wire of the aftermarket radio.
•
TheGMLAN11-100comessetupforamplifiedsystems. Ifthevehicleisnotamplified
disconnectthe4pinharnesslocatedbetweenthe30wayand22wayconnector.
Connect the supplied 4 pin speaker harness and connect the following:
•
•
•
•
Connect the Violet wire to the right rear positive wire of the aftermarket radio
Connect the Violet/Black wire to the right rear negative wire of the aftermarket radio
Connect the Green wire to the left rear positive wire of the aftermarket radio
Connect the Green/Black wire to the left rear negative wire of the aftermarket radio
INSTALLING THE GMLAN11-100
•
With all the connections completed, plug the 20, 22, and 8 pin harnesses into the GMOS-
100i (sold separately).
1
•
•
Reconnect the negative battery terminal.
Plug the 30 pin GM harness into the vehicle side harness, and plug the aftermarket radio
harnessintotheaftermarketradio.
•
Cycle the key by turning the ignition on then back off, then back on again to test the radio.
PROGRAMMINGSWC
•
•
Turn on the ignition
The LED will begin to blink rapidly
The following buttons must be pressed in the following order:
Volumeup, Seekup, Band, PTT/Mute, Fanup(Eachbuttonpresswillbeacknowledgedwith
the LED on steadily)
Ifanyoftheabovebuttonsarenotpresent, substitutewithVolumeup. Forexample, ifa
vehicle does not Band and Fan up, you would press Volume up, Seek up, Volume up, PTT/
MUTE, Volume up.
Afteryouhavepressedfivebuttons, theLEDwillturnoff, thenblinkanumberoftimes
accordingtothedetectedvehicletype. IfSWCdoesnotrecognize, pleasenotethenumberof
blinksandcontacttechsupport.
If you press the buttons incorrectly, turn off the ignition and repeat the above steps. If you do
itwrong, itcanbedoneagainbypressingthevolumeupbuttonfor15secondsuntiltheLED
goesintofastblinkmodeagain.
TESTING THE GMLAN11-100
•
•
Turntheignitionon, andthenturntheaftermarketradioon.
PushtheOnstarbutton, theradioshouldturnoff(radiowillmuteifmutewireis
connected)andyoushouldhearOnstar.
•
Push the Onstar cancel button and the radio should come back on.
2
NOTES
NOTES
INSTALLATION INSTRUCTIONS FOR PART GMLAN11-100
1-800-221-0932
axxessinterface.com
© COPYRIGHT 2004-2010 METRA ELECTRONICS CORPORATION
|