Mellerware Vacuum Cleaner VAC20002000W User Manual

E X E C U T I V E  
I N S I G N I A V A C U U M C L E A N E R  
complies with  
INTERNATIONAL  
M o d e l :  
VAC2000  
IEC60355  
2000W max  
SAFETY SPECIFICATIONS  
PLEASE READ ALL INSTRUCTIONS BEFORE USE  
2 y e a r g u a r a n t e e  
VAC2000_IM.indd 1  
2010/11/22 08:35:33 AM  
 
Safety Warning  
switched off.  
20. CAUTION! The appliance has a rapid cord  
reel mechanism, please take extra care  
when retracting the cord.  
For household use only!  
1. When using the cleaner, you should adhere to  
the following basic safety precautions:  
2. Please unplug the appliance when not in use or  
before maintenance.  
21. Do not use the appliance other than for its  
intended use and beyond the scope of this  
User’s Guide.  
3. In order to reduce the danger of electric shock, 22. When using the appliance, please ensure  
please don’t use outdoors or on a wet surface.  
4. Don’t use as a toy for children, please pay close  
attention to safety when a child uses or comes  
close to the cleaner.  
that the correct voltage supply is adminis-  
tered as the incorrect voltage and current  
can cause the cord to heat up and become  
soft.  
5. Use only the accessories described in the Guide 23. This appliance should be stored in a cool  
and provided by the factory. and dry area.  
6. Do not use with damaged cord or plug. If cleaner 24. When using the appliance take care not to  
is not working as it should, has been dropped, stumble over the cord!  
damaged, left outdoors, or dropped into water, 25. Please don’t immerse the appliance in the  
or if the cord is damaged. Return it to an ap- water or other liquids;  
pointed customer repair center for check, repair 26. Please don’t use the appliance to clean  
or regulation. your pets or other animals;  
7. The appliance cord should not be used as a 27. Please keep suction inlet away from ear  
handle to pull and lift the appliance. Do not al-  
low cord to be submerged in tight spaces Ie. be-  
tween room door and door frame. Do not allow  
area due to excessive noise levels when in  
operation.  
cord to come into contact with sharp edges and Important points:  
surfaces. Do not allow the appliance to run over If reduced suction occurs, below is a list of  
the cord. Do not allow the cord to come into con- causes:  
tact with any heat surface.  
8. Do not pull the cord when removing the plug  
from the mains socket.  
9. Don’t touch the plug or operate the cleaner with  
wet hands.  
10. Do not allow objects to restrict airflow or to block  
airflow.  
11. Do not allow any body parts Ie. hair, fingers,  
hand etc to block the airflow of the cleaner as  
this puts unnecessary strain on the motor and  
can cause the motor to burn out.  
12. Please don’t use the cleaner to absorb hard or  
sharp objects such as the glass, nails, screws,  
coins, etc., otherwise the machine or the HEPA  
filter will be damaged.  
1. The extension tube or hose could be  
blocked. Switch off the appliance and clear  
the extension tube or hose before continu-  
ing.  
2. HEPA filter could be blocked due to not be-  
ing cleaned regularly, or the bagless dust  
compartment is full and should be cleaned.  
While operating the cleaner, one should  
keep it far away from a heat or radiant  
source;  
Before cleaning commences, please en-  
sure that the appliance with all hoses and  
extension tubes are free of large or sharp  
objects as this can cause damage to the ap-  
pliance or accessories.  
13. Do not use this machine to clean hot objects and  
substances as this will cause damage to the ap-  
pliance.  
14. Do not use the appliance unless the bagless  
dust compartment and HEPA filter are inserted.  
15. Please ensure that the appliance is switched off  
before inserting and removing the plug from the  
mains socket.  
When removing the plug from the socket,  
do not pull the cord, place hand directly on  
the plug and remove from the socket.  
Should the appliance make a strange or  
abnormal sound or noise during operation.  
switch off the cleaner. Clean out the appli-  
ance and all the piping as well as ensure  
that all accessories are attached correctly to  
the cleaner.  
16. Take special care when using the cleaner to  
clean a flight of stairs.  
17. Please don’t use the cleaner to absorb com- Remarks:  
bustible or inflammable liquids (cleaning liquid, This appliance is fitted with a cord rewinder  
gasoline, perfume and so on) or use it in the area mechanism. If the cord, plug or mechanism is  
where they may possibly exist;  
damaged, please take the appliance to the near-  
18. Do not use this appliance to clean up toxic sub- est repair centre so that the damaged compo-  
stances (bleaching powder, ammonia water and nents can be repaired by the correct personnel.  
so on);  
19. When connecting or disconnecting hose from  
appliance, please ensure that the appliance is  
VAC2000_IM.indd 3  
2010/11/22 08:35:50 AM  
 
Use and function  
3. Ideal cord reel method is as follows: Place plug  
in one hand and using the other hand, press  
cord reel button to rewind cord. By keeping the  
plug in one hand, this allows cord to be retract-  
ed properly and not allow cord to get tangled  
during rewind process.  
A Guide to Assembling  
Caution:  
Be sure to cut off power and dismantle accesso-  
ries before assembling.  
Join hose and cleaner by means of joining hose at  
suction inlet .  
(Fig. 1)  
4. Thermal cut-out:  
This appliance has been fitted with a thermal cut-  
out to protect the motor from destruction or harm,  
should the operating temperature exceed the safe  
operating temperature. If the appliance cuts out, re-  
move the plug from the socket and allow the appli-  
ance to cool down. Also check all piping and tubes  
for obsticles blocking or restricting airflow. Clean out  
bagless dust compartment and HEPA filter. Allow the  
appliance to cool down for 1 hour before reuse.  
Move and transporting the appliance:  
Caution:  
A special handle is provided with this appliance  
Insert the hose into the suction and turn it clock- which will enable you to move and transport this  
wise.  
appliance comfortably. There is also a specially  
designed grip handle on the bagless dust compart-  
Assembling hose handle to extension tube:  
To attach the hose handle to the extension tube, ment to move or transport the appliance. Please  
insert the bottom of the hose handle into the top note: Do not use the grip handle of the bagless dust  
of the extension tube (as shown in figure 2). The compartment to move or transport the appliance.  
amount of suction may also be adjusted by using This can cause damage to the compartment as well  
the air regulator vent on the hose handle.  
(Fig. 2)  
as cause the appliance to malfunction.  
(Fig. 4)  
Control of suction force:  
Caution:  
Once all the accessories have been attached to  
the the appliance, remove the desired length of  
cord required. The yellow mark on the cord is the Cleaning the HEPA filter:  
recommended ideal cord length. The cord should Warning:  
not be removed beyond the red mark.  
1. Insert the power plug;  
Before any cleaning is done, please ensure that the  
appliance is switched off and that the appliance plug  
2. Press down the switch button of the cleaner, is removed from the socket.  
keep it ON ; make the suction power stronger 1. Press the release button of the bagless dust  
by turning it clockwise and make weaker by  
turning it anticlockwise.  
(Fig. 3)  
compartment, found on the dust grip handle.  
Remove the bagless dust compartment from  
the appliance. Release the button of the ba-  
gless dust compartment once compartment  
has been fully removed.  
2. Once the compartment has been removed,  
open the hatch of the compartment to empty all  
dust and dirt as shown in Fig. 6.  
(It is essential to empty bagless dust compartment  
once dust level reaches maximum capacity. Also re-  
move HEPA filter and clean separately.)  
Switch button  
Cord rewinder  
button  
VAC2000_IM.indd 4  
2010/11/22 08:35:50 AM  
 
(Fig. 5)  
cessories are inserted and attached correctly.  
Caution:  
Use the button on  
the handle  
The motor filter is installed behind the air outlet  
grid, open up the air outlet grid and it may be taken  
out;  
To remove the motor outlet filter, remove the rear  
grid (as shown in Fig. 9). To replace the filter of the  
motor outlet filter, insert filter into designated area  
followed by inserting the grid into place by clicking  
the clips into the slots.  
(Fig. 9)  
3. Remove the HEPA filter as shown in Fig. 7  
and 8.  
(Fig. 6)  
Air Outlet filter  
Move the clip  
on tank bottom  
cover  
How to replace and clear the air outlet filter:  
The air outlet filter should be cleaned or replaced  
every 6-12 months of use. Please ensure to cor-  
rectly replace all filters before switching on the ap-  
pliance.  
4. When cleaning the HEPA filter, use a gentle  
bristle brush to remove fine dust particles.  
(Fig. 7)  
(Fig. 8)  
1. Ensure the appliance is switched off and that  
the plug is removed from the socket.  
2. Open the air outlet grid.  
3. Remove the filter for cleaning. Also remove  
any excess dust which is lying in the air outlet  
vent.  
4. Replace the filter and insert ait outlet grid into  
place until grid “clicks” into slot.  
Replace the motor filter:  
In order to ensure the best air outlet effect, some-  
times you need to clear the air outlet filter.  
1. Take off the air outlet grid and take out the  
filter.  
2. Clear the air outlet filter or replace it with a  
new filter.  
5. Once HEPA filter cleaning is complete, insert  
HEPA filter back into designated area by turn-  
ing clockwise until filter locks into place.  
6. Insert compartment back into appliance until  
compartment “clicks” into place. Attach hose  
to applance and switch on cleaner to ensure  
that cleaner is working correctly.  
Caution:  
Do not be alarmed if over time the HEPA filter  
changes colour. This is normal and will not have  
an effect on the operation of the appliance. Should  
cleaning of the filter not be successful, rinse the  
filter in water. Once complete, allow the filter to dry  
naturally for 24 hours.  
Key points:  
Please note that the appliance is able to operate  
without the HEPA filter and bagless dust compart-  
ment, but it is not advised as this can cause the  
appliance to malfunction. Before using this appli-  
ance, always ensure that all compartments and ac-  
VAC2000_IM.indd 5  
2010/11/22 08:35:50 AM  
 
27 Nourse  
Avenue Epping  
2
Cape Town  
P.O. Box 975 Eppindust 7475 South Africa  
Tel: +27 21 534 8114 Fax: +27 21 534 8086  
Service Centre Share Call: 086 111 5006  
w e b : w w w. c r e a t i v e h o u s e w a r e s . c o . z a  
VAC2000_IM.indd 6  
2010/11/22 08:35:50 AM  
 

Kyocera Conference Phone Koi User Manual
LeapFrog Handheld Game System 19150 User Manual
Lenovo Laptop Y550P User Manual
LG Electronics DVD Player LST 3510A User Manual
Lightolier Indoor Furnishings WES SERIES 2X4 User Manual
Makita Drill 6000LR User Manual
Manitowoc Ice Ice Maker 7626803 User Manual
Maverick Ventures Thermostat ET 68 User Manual
Mellerware Blender 8 5 3 0 0 User Manual
Memorex CD Player MC1009 User Manual