SOLID STATE RELAY ASSY.
FOR CA200, CA260, FA290 AND HA300 DISPENSERS
IMPORTANT
Before replacing this relay on a QPA310 ice dispenser:
Check for moisture on the two-pin Molex connector for the dispense switch
wiring harness.
If moisture is present, dry and seal the ends of the connector with silicone
sealant.
Moisture on this connector can simulate a defective relay.
Black Power Cord
Black T3
Black Power Cord
Vend Switch
Black
Vend Switch
Black
Gear Motor
Black T3
Switch
1
Gear Motor
Switch
Sinpac
Switch
2
White
White
Power Cord
White
Sinpac
Switch
Solid State
White
White
White
Power Cord
4
3
Coil
Coil
Capacitor
1.88
Junction Box
CA200/CA260
Drill one .136 dia. hole for solid state relay.
Attach relay with two screws provided.
Capacitor
1.88
Junction Box
FA290/HA300
Drill two .136 dia. holes for solid state relay.
Attach relay with two screws provided.
Manitowoc Ice, Inc.
2110 South 26th Street, P.O. Box 1720, Manitowoc, WI 54221-1720 USA
Telephone 920-682-0161, Fax - Sales: 920-683-7589, Service/Parts: 920-683-7585, Other: 920-683-7879
8010213
Rev. 08/20/03
|