GAS APPLIANCE
KITS AND ACCESSORIES
750,222M
REV. A 07/2006
GAS CONVERSION KIT
WARNING: THIS CONVERSION KIT SHALL BE AVERTISSEMENT: CET ÉQUIPEMENT DE CONVERSION
INSTALLED BY A QUALIFIED SERVICE AGENCY IN
SERAINSTALLÉPARUNEAGENCEQUALIFIÉEDESERVICE
ACCORDANCE WITH THE MANUFACTURER'S IN- CONFORMÉMENT AUX INSTRUCTIONS DU FABRICANT ET
STRUCTIONS AND ALL APPLICABLE CODES AND TOUTES EXIGENCES ET CODES APPLICABLES DE
REQUIREMENTS OF THE AUTHORIZED HAVING
L'AUTORISÉSAVOIRLAJURIDICTION. SIL'INFORMATION
JURISDICTION. IF THE INFORMATION IN THESE DANS CETTE INSTRUCTION N'EST PAS SUIVIE
INSTRUCTIONS IS NOT FOLLOWED EXACTLY, A EXACTEMENT, UN FEU, EXPLOSION OU PRODUCTION DE
FIRE, EXPLOSION OR PRODUCTION OF CARBON
PROTOXYDEDECARBONEPEUTRÉSULTERLEDOMMAGES
MONOXIDE MAY RESULT CAUSING PROPERTY CAUSER DE PROPRIÉTÉ, PERTE OU BLESSURE
DAMAGE, PERSONAL INJURY OR LOSS OF LIFE. PERSONNELLEDEVIE. L'AGENCEQUALIFIÉEDESERVICE
THE INSTALLATION IS NOT PROPER AND COM-
EST ESPONSABLE DE L'INSTALLATION PROPRE DE CET
PLETEUNTILTHEOPERATIONOFTHECONVERTED ÉQUIPMENT. L'INSTALLATION N'EST PAS PROPRE ET
APPLIANCE IS CHECKED AS SPECIFIED IN THE COMPLÉTE JUSQU'À L'OPÉRATION DE L'APPAREIL
OWNERINSTRUCTIONSSUPPLIEDWITHTHEKIT.
CONVERTI EST CHÉQUE SUIVANT LES CRITÈRES ÉTABLIS
THE QUALIFIED SERVICE AGENCY PERFORMING DANS LES INSTRUCTIONS DE PROPRIÉTAIRE
THIS INSTALLATION ASSUMES RESPONSIBILITY PROVISIONNÉES AVEC L'ÉQUIPEMENT.
FOR THIS CONVERSION.
In Canada:
Step 1. Turn off the gas supply to the appli-
ance and disconnect the electrical power.
Gas Conversion Kits
THE CONVERSION SHALL BE CARRIED OUT
IN ACCORDANCE WITH THE REQUIREMENTS
OF THE PROVINCIAL AUTHORITIES HAVING
JURISDICTION AND IN ACCORDANCE WITH
THE REQUIREMENTS OF THE CAN1-B149.1
AND .2 INSTALLATION CODE.
Models
LP To Nat
Nat To LP
Step 2. Carefully remove the logs. Exercise
care so as not to break the logs. Remove any
lava rock within the burner pan.
E36ODG
E42ODG
Catalog No.
H4915
Catalog No.
H4916
E36ODG
Model No.
Model No.
E42ODG GCK-DB140N GCK-DB078P
Step 3. Remove the burner tube with attached
venturi tube. Refer to Figure 1 for the location
of the control valve and regulator, main orifice
and pilot.
LA CONVERSION DEVRA ÊTRE EFFECTUÉE
CONFORMÉMENTAUXRECOMMANDATIONS
DES AUTORITÉS PROVINCIALES AYANT
JURIDICTION ET CONFORMÉMENT AUX
EXIGENCESDUCODED'INSTALLATIONCAN1-
B149.1 ET.2.
Burner Tube
Pilot Orifice
Gas conversion kits are available to adapt your
appliancefromtheuseofonetypeofgastothe
use of another. These kits contain all the nec-
essary components needed to complete the
task including labeling that must be affixed to
ensure safe operation.
Main
Orifice
Kit part numbers are listed here and the follow-
ing steps detail the conversion procedure.
Access
Cover
CAUTION: THE GAS SUPPLY SHALL BE SHUT
OFF PRIOR TO DISCONNECTING THE ELEC-
TRICALPOWER,BEFOREPROCEEDINGWITH
THE CONVERSION.
Control Valve
And Regulator
Figure 1
NOTE: DIAGRAMS & ILLUSTRATIONS NOT TO SCALE.
|